Door Stops| Fiat Toilet Partition
All keeper bumpers and stops are in stock for fast delivery. We carry in stock chrome plated, cast stainless steel and aluminum partition keeper bumpers. Replacing old hardware with new will change your bathroom's to looking new again. All partition keeper bumpers will come with security screws. All throw latch keepers are required for all handicap doors over 32", 34", 36" width for easy access to the inside door.
-
Fiat Partition Keeper Bumper Inswing
The Fiat Partition Keeper Bumper Inswing is for use on 1-1/4" thick square edged pilaster posts. It is constructed of Zamac die cast metal that is then chrome plated and polished. The strike and keeper is 2-1/2" tall by 1-7/8" wide. The stop sticks out 3/4" and has a rubber bumper on it. The two mounting screws are 1-1/2" on center. The latch bolt slot is 1-9/16" high by 5/16" deep. This keeper bumper is designed for use on a 1-1/4" Post or Pilaster for inswinging doors. Also known as a Bathroom Stall Strike and Keeper-Inswing 1-1/4". Manufacture part # 5110. Shipped with mounting screws.
9F0304 -
Fiat Partition Keeper Bumper Outswing
The Fiat Partition Keeper Bumper Outswing is designed to be mounted on 1-1/4" square edged pilaster posts. It is constructed of Zamac die cast metal that is then chrome plated and polished. The strike and keeper is 2-1/2" tall by 1-7/8" wide. The stop sticks out 3/4" and has a rubber bumper on it. The two mounting screws are 1-1/2" on center. This keeper bumper is designed for use on a 1-1/4" Post or Pilaster for outswinging doors. Also known as a Bathroom Stall Strike and Keeper-Outswing 1-1/4". Manufacture part # 5210. Shipped with mounting screws.
9F0303
