Door Stops
All keeper bumpers and stops are in stock for fast delivery. We carry in stock chrome plated, cast stainless steel and aluminum partition keeper bumpers. Replacing old hardware with new will change your bathroom's to looking new again. All partition keeper bumpers will come with security screws. All throw latch keepers are required for all handicap doors over 32", 34", 36" width for easy access to the inside door.
-
No Sight Partition Door Gap Filler Kit
Global partitions No sight partition door gap filler for powder coated steel partitions or stainless steel material. The doors are typically 1" thick. The hinge side filler has a slight round edge. On the latch side there is also a slight round edge for mounting, there is a built in notch for the slide bolt that comes out the center of the doors to lock into. This kit can be used for an in swing or out swing door. The construction is aluminum and easy to shorten if needed. This product is used with 1-1/4" edge with a slight round edge to it. All security screws included for installation. The product is made by Global Partitions with part numbers 40-8443721.
9A8443721 -
Continuous Door Stop for 1-1/4" Pilaster
Toilet partition continuous door stop for powder coated steel partitions, this has a slight round edge for attaching. The length is 57" and is used on a 1-1/4" slight round edge pilaster for mounting. Used with 1" doors and has a concealed turn latch with the pin coming out the center edge of the door. The hole spacing for the slot is 28-1/2" dead center of unit. The slot for the bolt to lock to is 7/16" wide x 5/8"ht. This helps with blocking the door gaps on the locking side of the door. This is made of brushed aluminum material and is used with in or out swing doors. Also known as Hadrian partitions part number 560058.
9A560058 -
Full Length Door Stop for 1" panel Inswing
Toilet partition full length aluminum door stop for 1" panel Inswing doors. This product is clear anodized aluminum. This full length door stop with block the gap between the door and the post next to it. For an inswing the slot is 3/8"x1-1/4" wide for the slide latch to latch it. The door keeper and strike is 54" in length and has 5 holes spaced at 13" apart and starts at 1" from the top and the bottom. Also known as 134304 strike & keeper channel. Includes all hardware.
9A134304 -
Full Length Aluminum Door Stop for 1" panel outswing
Toilet partition full length aluminum door stop for 1" panel outswing doors. This product is clear anodized aluminum. This full length door stop with block the gap between the door and the post next to it. For an outswing the latch locks on the back side of the bumper. The door keeper and strike is 54" in length and has 5 holes spaced at 13" apart and starts at 1" from the top and the bottom. Also known as 134314 strike & keeper channel. Includes all hardware.
9A134314
