Door Stops| Sanymetal Toilet Partition
All keeper bumpers and stops are in stock for fast delivery. We carry in stock chrome plated, cast stainless steel and aluminum partition keeper bumpers. Replacing old hardware with new will change your bathroom's to looking new again. All partition keeper bumpers will come with security screws. All throw latch keepers are required for all handicap doors over 32", 34", 36" width for easy access to the inside door.
-
Partition Keeper For Throw Latch
The Partition Keeper For Throw Latch is for use on inswinging doors. Keeper base is 2-1/2" high by 1-3/16" wide with a 1-1/2" hole spacing. Strike is 2-1/2" tall by 7/8" deep. The material 1/8" thick. The slot is 13/16" high by 1/4". They are constructed of Zamac die cast metal that is then chrome plated and polished. Also known as a Bathroom Stall Keeper Inswing Flat. Manufacture part # 5180. Shipped with mounting screws.
9S2701 -
Sanymetal Toilet Partition Door Stop
The Sanymetal Toilet Partition Door Stop is constructed of Zamac die cast metal that is then chrome plated and polished. The strike and keeper measure 2-1/2" high by 1-7/8" deep by 1/8" thick. The stop has a 3/4" projection and is 9/16' deep with a rubber insert. The mounting holes are 1-1/2" on center. Also known as a Bathroom Stall Strike and Keeper Inswing/Outswing Flat. Manufacture part # 5170. Shipped with mounting screws.
9S2704 -
Partition Inswing Keeper For Throw Ltc For 1-1/4" Sq Post
The Partition Inswing Keeper For Throw Latch for use on a 1-1/4" Square Post or pilaster. They are constructed of Zamac die cast metal that is then chrome plated and polished. The strike and keeper measure 2-1/2" high by 1-7/8" wide with a hole spacing of 1-1/2" on center. The stop is 2-1/2" tall by 3/4" wide with a rubber insert. The slot measures 13/16" high by 1/4" deep. Commonly known as a Bathroom Stall Strike and Keeper Inswing 1-1/4". Manufacture part # 5340. Shipped with mounting screws.
9S410T -
Sanymetal Toilet Partition Keeper 2" Between Screws
The Sanymetal Toilet Partition Keeper 2" Between Screws is constructed of Zamac die cast metal that is then chrome plated and polished. Keeper base is 3" high by 1-1/16" wide with a 2" hole spacing. Strike is 3" tall by 7/8" deep. The material 1/8" thick. The slot is 1-1/8" high by 1/4". Also known as a Bathroom Stall Keeper Inswing Flat. Manufacture part # 5130. Shipped with mounting screws.
9S2401
